Adjusting knitting machine 4
Advanced adjustments 4.2
162
7. To stop the carriage assembly on the left side outside the needle bed,
tap the "S<" or "S>" key and start the machine with the engaging rod.
8. To move the carriage assembly a few centimeters to the right, tap the
"S>" key, start the machine with the engaging rod and stop it again
immediately. The carriage assembly must still be positioned outside the
needle space.
9. Switch back to the previous window.
Calling up and correcting
machine data
1. Call up the "Basic settings" menu.
2. Call up the "Machine parameters" window.
3. Compare the displayed values with the target values on the machine
data sheet and if necessary correct the values in the window "Machine
parameter" and confirm them.
4. Switch back to the previous window.
5. Call up the "Needle bed parameters" window.
6. Compare the displayed values with the values on the machine data
sheet. If necessary, correct the values on the machine data sheet.
7. Switch back to the previous window.
8. Call up the "NPK values" window.
9. Compare the displayed values with the target values on the machine
data sheet. If necessary, correct the values in the "NPK values" window
and confirm them.
10. Switch back to the previous window.
11. Call up the "Needle selection" window.
12. Compare the displayed values with the target values on the machine
data sheet. If necessary, correct the values in the "needle selection"
window and confirm them.
13. Call up the "Main menu".
To Next Page
Loading...
