Repairing the knitting machine 7
Replacing parts 7.3
326
11. Mount the suction tubes again.
12. Mount the carriage assembly panelling.
13. Close the covers.
14. Switch on 40 V power supply.
15. Call up "Main menu".
16. Call up "Machine start" window.
17. Tap the "SPF line fixed" key.
18. Start the machine with the engaging rod.
The yarn carriers move automatically back into their knitting
position, then the carriage starts moving.
19. Only if the carriage assembly was blocked: If the carriage stops after the
left reversion, set the needle selection to "On" in the "Machine start"
window.
20. Tap in "Machine start" window on key "SP from line 1" to start
production.
Further information:
Switching power supply 40 V off and on [-> 297]
Separating the suction tubes from the carriage [-> 300]
Sliding board [-> 302]
To Next Page
Loading...
