Software - Installation and basic settings 8
Installing the Stoll operating system 8.4
396
8. Confirm selection.
The installation process gets started.
The "Language" window is displayed after having selected the
"Installation without configuration" check box.
- or -
The "Reference runs" window is displayed after having selected the
"Installation without configuration" check box.
9. If the "Language" window is displayed, continue with the Machine
configuration section.
- or -
➜ If the "Reference runs" window is displayed, continue with the Start
Reference runs section.
Configure machine ✔ The "Language" window is displayed.
1. Select the dialog language and confirm the selection.
2. Proceed to the next window.
The "Machine configuration" window is displayed. The data have
been set at the factory and will not be changed.
3. Proceed to the next window.
The "Machine configuration 2" window is displayed. The data have
been set at the factory and will not be changed.
4. Proceed to the next window.
The "Machine Options" window is displayed. The data is set at the
factory.
5. If necessary, change the data and confirm the changes.
6. Proceed to the next window.
The "Machine Parameter" window is displayed. The data is set at
the factory.
7. If necessary, change the data and confirm the changes.
8. Proceed to the next window.
The "Needle bed parameters" window is displayed. The data is set
at the factory.
9. If necessary, change the data and confirm the changes.
10. Proceed to the next window.
The "NPK-Values" window is displayed. The data is set at the
factory.
Machine fault!
The presence or lack of machine options must correctly be
specified, as otherwise a fault may occur on the machine.
Always specify the machine options correctly.
To Next Page
Loading...
