397
8 Software - Installation and basic settings
8.4 Installing the Stoll operating system
11. If other NPK values are to be used, change the values and confirm the
changes.
12. Proceed to the next window.
The "Knit Report Configuration" window is displayed.
13. If other settings are to be used, change the settings and confirm the
changes. Use the "additional function keys" to activate/deactivate the
running time control and/or running time measurement.
14. Proceed to the next window.
The configuration is complete.
The "Reference runs" window is displayed.
15. Continue with the next section.
Start reference runs ✔ The "Reference runs" window is displayed.
1. If the racking device is not in the home position, press off the stitches of
a needle bed.
2. Carry out reference run(s).
3. Proceed to the next window.
The installation process is complete and the "Main menu" is displayed.
Further information:
Configure machine [-> 372]
Configuring network [-> 374]
Load the machine settings in the machine computer [-> 378]
Saving dongle data [-> 378]
Updating software [-> 398]
To Next Page
Loading...
