110 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
--------------------------------------------------------------
|Signal |FrameType |CRC |SSMBit |zero suppression|
|------------|------------|--------|--------|----------------|
|e1 output |ccs |enable |all |off |
|............|............|........|........|................|
|t1 output |esf |na |na |na |
--------------------------------------------------------------
Port Config
--------------------------------------------------------
|Port |state |io dir |Signal /Format |
|------------|------------|------------|---------------|
|t1e1 |enable |output |t1 |
--------------------------------------------------------
Example 2:‘
TP2700> show output config pps10m
Response 2a:
1PPS output phase offset compensation: 0 ns
Port config
--------------------------------------
| Port | state | Signal/format |
|---------|---------|----------------|
| pps10m | enable | pps |
|.........|.........|................|
Response 2b:
1PPS output phase offset compensation: 0 ns
Port config
--------------------------------------
| Port | state | Signal/format |
|---------|---------|----------------|
| pps10m | disable | pps |
|.........|.........|................|
Response 2c:
1PPS output phase offset compensation: 0 ns
To Next Page
Loading...
Need help?
General