098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 109
Chapter 3
TimeProvider 2300/2700 CLI Command Set
show output
This command displays the current configuration or status for output signals for the
T1/E1 port and the PPS offset on the PPS/10M output port. The provisioning
displayed with the
show output config t1e1 command will apply to the T1/E1
port only when the IO-direction of the port is configured as OUTPUT with the
set
port-control t1e1 io output
command.
Command Syntax:
To display the configuration of the T1/E1 output port or 10MHz/PPS port:
show output config {t1e1 | pps10m}
To display the status of the T1/E1 output port:
show output status t1e1
To display the status of the TOD port:
show output status tod
Example 1:‘
TP2700> show output config t1e1
Response 1a:
Output Config
--------------------------------------------------------------
|Signal |FrameType |CRC |SSMBit |zero suppression|
|------------|------------|--------|--------|----------------|
|e1 output |ccs |enable |all |off |
|............|............|........|........|................|
|t1 output |esf |na |na |na |
--------------------------------------------------------------
Port Config
--------------------------------------------------------
|Port |state |io dir |Signal / Format |
|------------|------------|------------|----------------|
|t1e1 |enable |output |e1 |
--------------------------------------------------------
Response 1b:
Output Config
To Next Page
Loading...
Need help?
General