EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #167 background imageLoading...
Page #167 background image
098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 167
Chapter 3
TimeProvider 2300/2700 CLI Command Set
Note: QL is always ENABLE on ETH1.
Example 4:
TP2700> show synce status eth1
Response 4:
--------------------------------------------------------
| Port | Direction | Ethernet Mode | RxSSM | TxSSM |
|.......|...........|................|........|........|
| Eth1 | input | asynchronous | 0x0f | 0x0f |
|......................................................|
Example 5:
TP2700> show synce status eth2
Response 5:
--------------------------------------------------------
| Port | Direction | Ethernet Mode | RxSSM | TxSSM |
|.......|...........|................|........|........|
| Eth2 | output | synchronous | 0x0f | 0x0f |
............................................ ...........
Example 6:
TP2700> show synce status all
Response 6:
--------------------------------------------------------
| Port | Direction | Ethernet Mode | RxSSM | TxSSM |
|.......|...........|................|........|........|
| Eth1 | input | asynchronous | 0x0f | 0x0f |
|.......|...........|................|........|........|
| Eth2 | output | synchronous | 0x0f | 0x0f |
............................................ ...........
set synce
Use these commands to:
enable or disable the state for SyncE on the PTP-SyncE service port
enable or disable the QL state for PTP-SyncE service port

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish