Symmetricom TimeProvider 2700 User Manual

166 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
show synce
Use this command to display SyncE status and configuration.
Command Syntax:
show synce status {eth1 | eth2 | all}
show synce config {eth1 | eth2 | all}
Example 1:
TP2700> show synce config eth1
Response 1:
SyncE Config:
----------------------------
|Port |State |QL State|
|------|----------|--------|
|eth1 |enable |enable |
----------------------------
Example 2:
TP2700> show synce config eth2
Response 2:
----------------------------
|Port |State |QL State|
|------|----------|--------|
|eth2 |enable |enable |
----------------------------
Example 3:
TP2700> show synce config all
Response 3:
----------------------------
|Port |State |QL State|
|------|----------|--------|
|eth1 |enable |enable |
|......|..........|........|
|eth2 |enable |enable |
----------------------------

Symmetricom TimeProvider 2700 Specifications

General

Brand	Symmetricom
Model	TimeProvider 2700
Category	Network Hardware
Language	English