90 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
show input
This command displays the current configuration or status for input signals for the
T1/E1 port. The values displayed with this command will be applied to the T1/E1
port only when the IO-direction of the port is configured as an Input with the
set
port-control t1e1 io input
command.
Command Syntax:
show input config <port-name>
show input status <port-name>
Example 1:
TP2700> show input config t1e1
Response 1a:
Input config
-------------------------------------------------|
| signal | Frame Type | CRC | ssmbit |
|------------|-------------|---------|-----------|
| e1 input | cas | enable | 6 |
|............|.............|.........|...........|
| t1 input | esf | enable | na |
|................................................|
Port config
----------------------------------------------
| Port | State | Io dir | Signal/format|
|--------|---------|----------|--------------|
| t1e1 | enable | input | e1 |
|........|.........|..........|..............|
Response 1b:
Input config
-------------------------------------------------|
| signal | Frame Type | CRC | ssmbit |
|------------|-------------|---------|-----------|
| e1 input | cas | enable | 6 |
|............|.............|.........|...........|
| t1 input | freq1544khz| na | na |
|.................................................|
To Next Page
Loading...
Need help?
General