EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #286 background imageLoading...
Page #286 background image
286 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Appendix A System Messages
System Notification Messages
1. The excessive traffic alarm is set if the count of Ethernet packets received in one second exceeds a
threshold. All traffic received by the TP2700 Ethernet ports is counted, such as ARP, ICMP, IGMP, PTP
unicast signaling, multicast, and PTP management messages.
Threshold:
1200 packets/sec for each port
System log time has
been updated
154 Event Yes System log time has been
updated
n/a
Not supported at this time
n/a
System reboot 155 Event Yes System reboot
n/a
No action required
n/a
Table A-2. Secondary Index Descriptions for System Notification Messages
Event
ID
Description
Secondary
Index
Secondary Index
Description
001 Entered time/frequency warm-up
state
0 - 1 0=time
1=freq
002 Entered time/frequency free-run
state
0 - 1 0=time
1=freq
003 Entered time/frequency fast-track
state
0 - 1 0=time
1=freq
004 Entered time/frequency
normal-track state
0 - 1 0=time
1=freq
005 Entered time/frequency bridging
state
0 - 1
0=time
1=freq
006 Entered time/frequency holdover
state
0 - 1 0=time
1=freq
007 Entered time/frequency extended
holdover state
0 - 1 0=time
1=freq
008 Entered time/frequency holdover
recovery state
0 - 1
0=time
1=freq
Table A-1. System Notification Messages (Continued)
Description
Event
ID
Msg
Level
Trans-
itory
MsgText Corrective Action

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish