170 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
upgrade
Use this command to upgrade TimeProvider 2300/2700 firmware with the specified
filename. The user must provide the IP address, username, and password (when
prompted) of the FTP or SCP server where the firmware file is stored. The upgrade
will take approximately 7 minutes to complete.
Command Syntax:
upgrade <filepath> {ftp: | scp:} <ftp-ip-address> <username>
Remarks: Firmware upgrades will not be implemented until the system is rebooted.
Example 1:
To upgrade the TimeProvider 2300/2700 using the upgrade file path of
“/symm/TimeProvider_EdgeMaster/current_upd”, FTP server IP address
192.168.5.56, username: “bob321”, Password: “bob123!”.
TP2700> upgrade /symm/TimeProvider_EdgeMaster/current_upd
ftp:192.168.5.56 bob321 <enter>
Response 1:
Password: bob123! <enter>
Do you want to restart the module after the firmware is
upgraded?
Please Confirm (yes|no): <enter>
Upgrade of TIMEPROVIDER is in progress
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Upgrade of TIMEPROVIDER is successfully completed
Example 2:
Note: The FTP firewall is set to “Block” by default. Use the following
command to set the firewall to “Allow” for ftp communications:
set firewall mgmt ftp allow
Note: The TimeProvider 2700 only supports active FTP; it does not
support passive (PASV) mode.
To Next Page
Loading...
Need help?
General