EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #205 background imageLoading...
Page #205 background image
098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 205
Chapter 4 Provisioning
Provisioning Input Parameters
Figure 4-11. Set PTP Client Config Command Hierarchy (cont’d)
Example 1 - Telecom-2008 Profile
Use the following procedure to configure the ETH1 port as a PTP client input with
the Telecom-2008 profile, no VLAN:
1. Type
set ptp client active-profile eth1 telecom-2008 and press
Enter.
2. Type
set ptp client config eth1 telecom-2008 ptp-state enable and
press Enter.
3. Type
set ptp client config eth1 telecom-2008 ttl 10 and press Enter.
4. Type
set ptp client config eth1 telecom-2008 dscp 8 and press Enter.
5. Type
set ptp client config eth1 telecom-2008 unicast-negotiation
enable
and press Enter.
Note: A license is required to enable PTP input client functionality on
the TP 2700.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish