EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #96 background imageLoading...
Page #96 background image
96 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
show ip
This command displays the Host, Mask, and Gateway IP addresses for Ethernet
interfaces. It also indicates if DHCP is enabled and if the port is enabled.
Command Syntax:
To show the configuration of the Ethernet interface (some settings will only be
implemented after restarting the IP interface):
show ip config {mgmt | eth1 | eth2}
To show the current status of the Ethernet interfaces for the specified module:
show ip status {mgmt | eth1 | eth2}
Example 1:
To display the configuration of the Ethernet interfaces for the MGMT module:
tp2700> show ip config mgmt
Response 1:
MGMT PORT PARAMETERS
IP mode : dhcp
IP state : enable
Static mode Parameters
IP address : 192.168.0.100
IP mask : 255.255.255.0
IP gateway : 0.0.0.0
DNS Domain : 192.168.0.100
DNS nameserver1 : 0.0.0.0
DNS nameserver2 : 0.0.0.0
Example 2:
To display the configuration of the Ethernet interfaces for the ETH1 port:
tp2700> show ip config eth1
Response 2:
ETH1 PORT PARAMETERS
IP state : enable
Note: Packet and byte counts do not include most PTP and NTP
packets.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish