Symmetricom TimeProvider 2700 User Manual

162 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
show status
Use this command to display the following system status information:
 Assigned System Name
 System Date And Time
 System Uptime
 Time Traceable
 Clock Frequency Status
 Clock Timing Status
 Frequency State Duration in Minutes
 Time State Duration in Minutes
 Currently Selected Timing reference Input
 Currently Selected Frequency reference Input
 Packet Service Eth1 mode: PTP client
 Packet Service Eth2 mode: PTP Master
 Eth1 active connector interface: RJ45
 Eth2 active connector interface: SFP
 Frequency Offset
 Phase Offset Value (Valid in fast-lock and normal states)
 Active Alarms #
 System Frequency PQL
Command Syntax:
show status
Example:
TP2700> show status
Response:
System name : Timeprovider
System Date and time : 2013-05-09,15:29:31
Time Traceable : YES
System uptime (sec) : 1976
Clock Frequency Status : NORMAL
Clock Time Status : NORMAL
Frequency State Duration (min) : 10
Time State Duration (min) : 10
Currently Selected Frequency reference : GNSS

Symmetricom TimeProvider 2700 Specifications

General

Brand	Symmetricom
Model	TimeProvider 2700
Category	Network Hardware
Language	English