EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #185 background imageLoading...
Page #185 background image
098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 185
Chapter 4 Provisioning
Managing the User Access List
Logging In
Use the following procedure to log in to the system at the admin level.
1. Ensure that the TimeProvider 2300/2700 is connected to a LAN, or directly
connected to a computer through the EIA-232 serial port. See Communications
Connections, on page 50.
2. If the TimeProvider 2300/2700 is connected to a LAN, Telnet or SSH from your
computer to the assigned IP address.
If the TimeProvider 2300/2700 is connected to a computer directly through the
serial port, start a Terminal session and press Enter.
3. Type your user name and press Enter. The system prompts for a password.
4. Type your password and press Enter. The system prompt appears.
Note: The telnet firewall is set to Block by default. Use the following
command to set the TP 2300/2700 firewall to Allow for telnet
communications:
set firewall mgmt telnet allow
Note: The default user name is “admin” and the default password is:
symmadmin**.
To avoid unauthorized access, you should change the default
password.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish