098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 315
Appendix B Specifications and Factory Defaults
Factory Defaults
Auto Negotiation Enable Enable | Disable
Speed All 100M | 1000M | All
Table B-32. PTP Client ETH1 Input Port Parameters
Description Default Value Value Range
PTP Active Profile Telecom-2008 Telecom-2008
PTP Priority - Time 2 1 to 10
PTP Priority - Frequency 2 1 to 10
PTP Use Configured PQL State Disable Enable | Disable
PTP Configured PQL - Time 3 1 to 16
PTP Configured PQL - Freq. 3 1 to 16
PTP State Enable Enable | Disable
TTL 64 1 - 255
DSCP 0 0 - 63
Two-step Disable Enable | Disable
Unicast-negotiation Enable Enable | Disable
Lease-duration 300 60 - 1000 seconds
Announce-interval 1 -3 to 4
Sync-interval -6 -7 to -5
Delay-req-interval -6 -7 to -5
Announce-receipt-timeout 3 2 to 10
Domain 0 0 -255
Transport Ethernet Ethernet
Service-tier sync-mask sync-mask | traffic-mask |
modified-traffic-mask
Asymmetry State Disable Enable | Disable
Asymmetry n/a Clear
Master Table 192.168.1.11 valid IPv4 address
Table B-31. PTP Client ETH1 Port IP Parameters (Continued)
Description Default Value Value Range