EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #88 background imageLoading...
Page #88 background image
88 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
show image
This command displays the firmware image and the firmware version in the system.
The backup image is the non-active image.
Command Syntax:
show image
Example:
tp2700> show image
Response:
SYSTEM IMAGE DETAILS
Active image : 2 1.0.3
Backup image : 1 1.0.2
Next boot image : 2
Level : User, Config, and Admin
set image
Use this command to provision the firmware image from which to boot. The backup
image is the non-active image.
Command Syntax:
set image {1 | 2}
Example 1:
Note: Each image has its own set of configuration data. When Image
1 is set as the boot image, the configuration data for Image 1 is
applied when the TP 2300/2700 is rebooted. When Image 2 is set as
the boot image, the configuration data for Image 2 is applied when the
TP 2300/2700 is rebooted.
A firmware upgrade is applied to the backup image, and the backup
image is set to be the next boot image. The TP 2300/2700 copies the
currently running configuration data to the data used with the next
boot. Therefore, the configuration should be the same after rebooting,
except for changes due to differences in supported configuration
items between firmware revisions.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish