Symmetricom TimeProvider 2700 User Manual

236 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 4 Provisioning
Testing TP 2300/2700 Provisioning
 The GNSS LED will be green if the reference is GNSS and the GNSS
engine/interface is operating normally. (TP 2700 only)
– The GNSS LED will be amber if the reference is GNSS and GNSS engine
or antenna is not tracking satellite.
– The GNSS LED will be OFF if the reference is not GNSS.
 The Clock LED should be GREEN.
 The Alarm LED should be OFF.
 The Ethernet MGMT port, LEDs on connector.
– LED on right side of connector should be green if link has been
established. (Left side is amber if there is a 100M link.)
– LED on left side of connector should flash amber if there is activity.
 ETH1 port LED will be green if a link has been established, flashing green if there
is activity. (Left side is amber if there is a 100M link.)
 ETH2 port LED will be green if a link has been established, flashing green if there
is activity. (Left side is amber if there is a 100M link.)
See Table 5-3 for additional details about LED conditions.
Verifying the Port IP Addresses
The IP addresses for the MGMT, ETH1 and ETH2 ports must each be on different
network/subnet.
MGMT Port
1. Log in to the TP 2300/2700 with a valid username and password.
2. Type
show ip config mgmt and press Enter.
a. Verify that the IP address-mode has the desired setting of DHCP or Static.
b. If the IP address-mode is set to “static”, verify that the IP address and mask
are the desired values.
c. Verify the State for the port is “enable”.
tp2700> show ip config mgmt
MGMT PORT PARAMETERS
IP mode : dhcp
IP state : enable

Symmetricom TimeProvider 2700 Specifications

General

Brand	Symmetricom
Model	TimeProvider 2700
Category	Network Hardware
Language	English