098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 237
Chapter 4 Provisioning
Testing TP 2300/2700 Provisioning
Static mode Parameters
IP address : 192.168.0.100
IP mask : 255.255.255.0
IP gateway : 0.0.0.0
DNS Domain : 192.168.0.100
DNS nameserver1 : 0.0.0.0
DNS nameserver2 : 0.0.0.0
4. Type show ip status mgmt and press Enter.
a. Verify that the IP address and mask match the configured values.
b. Verify that the third line of the results shows that the link is “UP”.
mgmt0 Link encap:Ethernet HWaddr 00:B0:AE:03:46:04
inet addr:192.168.5.44 Bcast:0.0.0.0 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1740774 errors:0 dropped:0 overruns:0 frame:0
TX packets:5591 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:83053919 (79.2 MiB) TX bytes:592651 (578.7 KiB)
ETH1 Input Port
1. Type
show ethernet config and press Enter.
a. Verify that the auto-negotiation and speed settings match the desired values.
b. Verify that the active-connector setting matches the connector being used.
----------------------------------------------
|Port| Auto-neg | Speed | Active-connector|
|----|------------|--------|-----------------|
|eth1| enable | all | r1-rj45 |
|----|------------|--------|-----------------|
|eth2| enable | all | r2-rj45 |
----------------------------------------------
3. Type show ethernet status and press Enter.
a. Verify that the speed for the port matches the settings.
eth1 current speed: 100M
eth2 current speed: 1000M
2. Type show ip config eth1 and press Enter.
a. Verify that the IP address and mask are the desired values.
b. Verify the State for the port is “enable”.
tp2700> show ip config eth1
To Next Page
Loading...
Need help?
General