Symmetricom TimeProvider 2700 User Manual

228 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 4 Provisioning
Provisioning Alarms
Figure 4-24. Set Alarm-Config Commands
Disabling Specific Alarms
The Set Alarm-Config command allows you to enable or disable specified alarms.
Example
To disable the GNSS antenna open-circuit alarm (alarm #33), enter the following:
1. Login at the Admin or Config-user level (see Logging In, on page 185).
2. Type
set alarm-config state alarm 33 disable and press Enter.
Showing Current Alarm Settings
The Show Alarm-Config command displays the set and clear alarm thresholds for
every alarm type.
Example

Symmetricom TimeProvider 2700 Specifications

General

Brand	Symmetricom
Model	TimeProvider 2700
Category	Network Hardware
Language	English