EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #156 background imageLoading...
Page #156 background image
156 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
show-session-timeout
For current opened user interface session, this command displays the inactivity
timeout to the defined time interval, in seconds. 0 means the time-out for this
session is disabled.
Command Syntax:
To display the session timeout:
show-session-timeout
Example:
TP2700>show-session-timeout
Response:
The current session timeout - 1800 sec
Level : User, Config, and Admin
set-session-timeout
This command sets the inactivity timeout to the defined time interval, in seconds.
This setting is only used for the current CLI session.
Command Syntax:
set-session-timeout <value>
Example:
TP2700>set-session-timeout 1800
Range: 0, 600 to 86400 seconds
Default: 900 seconds
Level : User, Config, and Admin

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish