EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #111 background imageLoading...
Page #111 background image
098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 111
Chapter 3
TimeProvider 2300/2700 CLI Command Set
Port config
---------------------------------------
| Port | state | Signal/format |
|---------|----------|----------------|
| pps10m | enable | 10MHz |
|.........|..........|................|
Example 3:
TP2700> show output status t1e1
Response 3a:
---------------------------
|io status |port status |
|------------|------------|
|t1 output |on |
---------------------------
Response 3b:
---------------------------|
| io status | port status |
|------------|-------------|
| t1 output | off |
...........................|
Response 3c:
Status: port is configured as input.
Response 3d
Status: port is disabled.
Level : User, Config, and Admin
set output
Use this command to configure output parameters for the T1/E1 and PPS/10M port.
When the T1/E1 port is configured as an output port, use this command to provision
all parameters for the output signal that are defined in ITU-T G.704:
Framing Type
CCS, CAS, or freq2048khz for E1
D4, ESF, freq1544KHz or isolateOne for T1 (isolateOne is for test
purposes only)
CRC state for E1

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish