132 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
set ptp
The command is used to provision the configurable parameters for PTP output
(master) and PTP input (client), including the profile selection, the attributes under
different profiles, and to provision the Grand Master table for PTP client.
See Table 3-3 for descriptions of the attributes specific to the Default (multicast)
PTP Master profile. See Table 3-4 for descriptions of the attributes specific to the
Telecom-2008 and ITU-T G.8265.1 (unicast) PTP Master profile. See Table 3-5 for
descriptions of the attributes specific to the PTP Client profile.
Command Syntax:
PTP MASTER - Default Profile Multicast Attributes:
To provision the active profile for PTP master with the Default (multicast) active
profile:
set ptp master active-profile eth2 default
To provision the state of the Two-Step Clock mode for the Master with the Default
(multicast) active profile:
set ptp master config eth2 default two-step {enable |
disable}
– If the Two-Step Clock state is Disable, a One-Step Clock is used.
To provision the timescale to Automatic, Arbitrary, or PTP for the Master with the
Default (multicast) active profile:
set ptp master config eth2 default timescale {auto| arb |
ptp}
Table 3-2. PTP Profiles
PTP Profile Syntax Transport Mode Description
Default default Layer 3 Multicast IEEE 1588-2008 Annex J
multicast over UDP/IP
Telecom-2008 telecom-2008 Unicast Generic unicast profile created
for telecom before ITU-T
G.8265.1
ITU-T G.8265-1
g8265-1
Unicast Telecom profile for frequency
sync described in ITU-T
G.8265.1