098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 133
Chapter 3
TimeProvider 2300/2700 CLI Command Set
– If the timescale is set to “auto”, the TP 2300/2700 will make the decision
based on the input. The TP 2300/2700 will set the timescale to “ptp” if the
unit is locked to GNSS or PTP. The TP 2300/2700 will set the timescale to
“arb” if the unit is locked to any other reference besides GNSS or PTP (i.e.,
E1, T1 or SyncE).
To provision the state for the Master with the Default (multicast) active profile:
set ptp master config eth2 default ptp-state {enable |
disable}
To provision the PTP priority-1 value for the Master with the Default (multicast)
active profile:
set ptp master config eth2 default priority-1
<priority-1-value>
To provision the PTP priority-2 value for the Master with the Default (multicast)
active profile:
set ptp master config eth2 default priority-2
<priority-2-value>
To provision the PTP domain value for the Master with the Default (multicast)
active profile:
set ptp master config eth2 default domain <domain-value>
To provision the PTP Diffserv Code Point value for the Master with the Default
(multicast) active profile:
set ptp master config eth2 default dscp <dscp-value>
To provision the PTP dither value for the Master with the Default (multicast)
active profile:
set ptp master config eth2 default dither {enable | disable}
To provision the IP Header Time to Live (TTL) field for PTP packets for the
Master with the Default (multicast) active profile:
set ptp master config eth2 default ttl <TTL-value>
To provision the announce receipt timeout value for a Master with the Default
(multicast) active profile:
set ptp master config eth2 default announce-receipt-timeout
<timeout-value>
To provision the announce interval value for a Master with the Default (multicast)
active profile:
set ptp master config eth2 default announce-interval
<announce-interval-value>
– The interval is 2
z
seconds, where z= <announce-interval-value>.
To Next Page
Loading...
Need help?
General