134 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
To provision the sync-interval value for a Master with the Default (multicast)
active profile:
set ptp master config eth2 default sync-interval
<sync-interval-value>
To provision the client-timeout value for a Master with the Default (multicast)
active profile:
set ptp master config eth2 default client-timeout
<client-timeout-value>
To provision the VLAN ID value for a Master with the Default (multicast) active
profile
set ptp master config eth2 default vlanid <vlanid-value>
PTP MASTER - Telecom-2008 Profile Attributes:
To provision the active profile to Telecom-2008 for PTP master:
set ptp master active-profile eth2 telecom-2008
To provision the state of the Two-Step Clock mode, for the Master with the
Telecom-2008 (unicast) active profile:
set ptp master config eth2 telecom-2008 two-step {enable |
disable}
– If the Two-Step Clock state is Disable, a One-Step Clock is used.
To provision the timescale to Automatic, Arbitrary or PTP for the Master with the
Telecom-2008 (unicast) active profile:
set ptp master config eth2 telecom-2008 timescale {auto| arb
| ptp}
– If the timescale is set to “auto”, the TP 2300/2700 will make the decision
based on the input. The TP 2300/2700 will set the timescale to “ptp” if the
unit is locked to gnss or ptp. The TP 2300/2700 will set the timescale to
“arb” if the unit is locked to any other reference besides gnss or ptp (i.e.,
E1, T1 or SyncE).
To provision the state for the Master with the Telecom-2008 (unicast) active
profile:
set ptp master config eth2 telecom-2008 ptp-state {enable |
disable}
To provision the PTP priority1 value for the Master with the Telecom-2008
(unicast) active profile:
set ptp master config eth2 telecom-2008 priority-1
<priority-1-value>
To Next Page
Loading...
Need help?
General