EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #114 background imageLoading...
Page #114 background image
114 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
show output-gen
This command displays the configuration for Output Port behavior during the
warm-up, free-run, fast-track and holdover states.
Command Syntax:
show output-gen
Example:
TP2700> show output-gen
Response:
Output generation configuration:
--------------------------------------------------------------
|Port |warm-up |free-run |holdover |fast-track |
|--------|------------|------------|------------|------------|
|t1e1 |squelch |squelch |on |on |
|........|............|............|............|............|
|tod |squelch |squelch |on |on |
--------------------------------------------------------------
Level : User, Config, and Admin
set output-gen
Use this command to provision the System's output port behaviors during the
warm-up, free-run, fast-track, and holdover states.
Command Syntax:
To provision the output generation behavior for the T1/E1 port:
set output-gen {warm-up| free-run | holdover |fast-track}
t1e1 {on | ais | squelch}
To provision the output generation behavior for the TOD port:
set output-gen {warm-up| free-run | holdover |fast-track}
tod {on | squelch}
Example 1:
To provision the output behavior to squelch during the free-run state for the T1/E1
port when it is configured as an output port:
TP2700> set output-gen free-run t1e1 squelch

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish