246 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 4 Provisioning
Testing TP 2300/2700 Provisioning
----------------------------
|Port |State |QL State|
|------|----------|--------|
|eth1 |enable |enable |
|......|..........|........|
|eth2 |enable |enable |
----------------------------
2. Type show synce status all and press Enter.
– Verify that the Ethernet Mode for ETH2 port is “synchronous”.
– Verify that the TxSSM values is consistent with quality needed for your
network.
-------------------------------------------------------
|Port |Direction |Ethernet Mode |RxSSM |TxSSM |
|--------|----------|---------------|--------|--------|
|eth1 |input |synchronous |0x02 |0x0f |
|........|..........|...............|........|........|
|eth2 |output |synchronous |0xff |0x02 |
-------------------------------------------------------
Verifying T1/E1 Functionality
T1/E1 Input
1. Type
show input config t1e1 and press Enter.
– Verify that the Input Configuration settings match the desired values.
– Verify that the IO Direction is “input”.
– Verify that the Port State is “enable”.
– Verify that the Signal/Format is set to the desired value.
Input config
----------------------------------------------
|signal |Frame Type |CRC |ssmbit |
|----------|---------------|--------|--------|
|e1 input |ccs |enable |8 |
|..........|...............|........|........|
|t1 input |esf |na |na |
----------------------------------------------
Port config
--------------------------------------------
|Port |State |IO dir |Signal |
|--------|--------|--------|---------------|
|t1e1 |enable |output |t1 |
--------------------------------------------