EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #247 background imageLoading...
Page #247 background image
098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 247
Chapter 4 Provisioning
Testing TP 2300/2700 Provisioning
2. Type show input status t1e1 and press Enter.
Verify that IO status matches the configured setting.
Verify that the input status is “OK”.
------------------------------------------------------------------------|
| Port | io status | input status | ssm | los | ais | oof | bpv | crc |
|------|-----------|--------------|-------|-----|-----|-----|-----|-----|
| t1e1 | e1 input | ok | ok | ok | ok | ok | ok | ok |
|.......................................................................|
or
------------------------------------------------------------------------------
|Port |input status|ssm |los |ais |oof |bpv |crc |
|---------|------------|--------|--------|--------|--------|--------|--------|
|t1 input |dis |na |na |na |na |na |na |
------------------------------------------------------------------------------
3. Use the procedure Verifying the Reference, on page 239 to check the reference
configuration and status.
Output
1. Type
show output config t1e1 and press Enter.
Verify that the Output Configuration settings match the desired values.
Verify that the IO Direction is “Output”.
Verify that the Port State is “enable”.
Verify that the Signal/Format is set to the desired value.
tp2700> show output config t1e1
Output Config
--------------------------------------------------------------
|Signal |FrameType |CRC |SSMBit |zero suppression|
|------------|------------|--------|--------|----------------|
|e1 output |ccs |enable |all |off |
|............|............|........|........|................|
|t1 output |esf |na |na |na |
--------------------------------------------------------------
Port Config
--------------------------------------------------------
|Port |state |io dir |Signal /Format |
|------------|------------|------------|---------------|
|t1e1 |enable |input |e1 |
--------------------------------------------------------

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish