EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #249 background imageLoading...
Page #249 background image
098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 249
Chapter 4 Provisioning
Testing TP 2300/2700 Provisioning
GPS time of week : 347953
GPS week : 1738
Leap second : 16
PPS status : 0
PPS Tacc : 7
Clock source : 2
Clock status : 6
Clock alarms : 0x2
Verifying 10 MHz/ 1PPS Functionality
1. Type show output config pps10m and press Enter.
Verify that the Signal/Format is the desired type.
Verify that the State is “enable”.
1PPS output phase offset compensation: 0 ns
Port config
--------------------------------------
| Port | state | Signal/format |
|---------|---------|----------------|
| pps10m | enable | pps |
|.........|.........|................|
Note: The Cisco TOD message format reports leap seconds using
TAI-UTC. The China Mobile TOD message format reports GPS leap
second using GPS-UTC.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish