EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #229 background imageLoading...
Page #229 background image
098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 229
Chapter 4 Provisioning
Provisioning Alarms
To display the configuration for all alarm types, enter the following:
1. Type
show alarm-config and press Enter.
Showing Current Alarms
The Show Alarm command displays all current alarms.
Example
To display a list of all current alarms enter the following:
1. Type
show alarm and press Enter.
Displaying Alarm and Unit Status
The Show Status command displays the system status information as follows:
Assigned System Name
System Date And Time
System Uptime
Time Traceable
Clock Frequency Status
Clock Timing Status
Frequency State Duration in Minutes
Time State Duration in Minutes
Currently Selected Timing reference Input
Currently Selected Frequency reference Input
Packet Service Eth1 mode: PTP client
Packet Service Eth2 mode: PTP Master
Eth1 active connector interface: RJ45
Eth2 active connector interface: SFP
Frequency Offset
Phase Offset Value (Valid in fast-lock and normal states)
Active Alarms #
System Frequency PQL
Example
To display the system status, type
show status and press Enter.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish