EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #242 background imageLoading...
Page #242 background image
242 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 4 Provisioning
Testing TP 2300/2700 Provisioning
|......|.....|....|..........|.........|.........| ........|
| 7 | 22 |42 | healthy | 240 | 47 | glonass |
|......|.....|....|..........|.........|.........| .........|
| 8 | 24 |42 | healthy | 85 | 29 | gps |
|......|.....|....|..........|.........|.........| .........|
| 9 | 26 |38 | healthy | 42 | 18 | gps |
|......|.....|....|..........|.........|.........|..........|
| 10 | 29 |42 | healthy | 150 | 26 | gps |
|......|.....|....|..........|.........|.........|..........|
| 11 | 21 |42 | healthy | 36 | 67 | gps |
|......|.....|....|..........|.........|.........|..........|
| 12 | 22 |42 | healthy | 240 | 47 | gps |
|......|.....|....|..........|.........|.........|..........|
| 13 | 24 |42 | healthy | 85 | 29 | gps |
|......|.....|....|..........|.........|.........|..........|
| 14 | 26 |38 | healthy | 42 | 18 | gps |
|......|.....|....|..........|.........|.........|..........|
| 15 | 29 |42 | healthy | 150 | 26 | glonass |
------------------------------------------------------------|
3. Use the procedure Verifying the Reference, on page 239 to check the reference
configuration and status.
Verifying PTP Master/Server Functionality
1. Verify the IP address for ETH2 Output Port per the above procedure.
2. Type
show ptp master active-profile eth2 and press Enter.
Verify that the active profile setting matches the desired profile type.
ETH2 PTP MASTER ACTIVE PROFILE : telecom-2008
3. Display the configuration details for the active profile type, whether “default”,
“itu-g8265-1” or “telecom-2008”. Each profile will have configuration settings,
even if is not the active profile. For this example, type
show ptp master config
eth2 telecom-2008
and press Enter.
Verify that the PTP State is “enable”.
Verify that the PTP parameter settings for the profile match the desired
settings.
ETH2 PTP MASTER CONFIGURATION WITH PROFILE TELECOM-2008:
PTP State : enable
PTP TTL : 64
PTP DSCP : 0
PTP Dither : disable
PTP Max Number Clients : 256
PTP Two Steps : disable
PTP Unicast Negotiation : enable
PTP Unicast Lease Duration : 300

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish