190 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 4 Provisioning
Provisioning the Ethernet Ports
Example
1. Login at the Admin or Config-user level (see Logging In, on page 185).
2. Type
set ip address-mode mgmt ipv4 dhcp and press Enter.
Static IP Mode
Use the following procedure to configure the TimeProvider 2300/2700 IP
parameters (Host Address, Subnet Mask, and Gateway Address) in Static IP mode
on the MGMT port. Use the dot-decimal notation format xxx.xxx.xxx.xxx to enter the
address parameter. See Figure 4-1.
Example
1. Login at the Admin or Config-user level (see Logging In, on page 185).
2. Type
set ip address-mode mgmt ipv4 static and press Enter.
3. Type
set ip ip-address mgmt ipv4 address 10.6.1.76 netmask
255.255.255.0 gateway 10.6.1.1
and press Enter.
4. Type
set ip state mgmt ipv4 restart and press Enter.
DNS Server
You can provision the DNS servers and domain for the Ethernet MGMT port. See
Figure 4-1.
Example
1. Login at the Admin or Config-user level (see Logging In, on page 185).
2. Type
set ip mgmt dns nameserver1 168.192.0.200 nameserver2
168.192.0.210 domain exampledomain.com
Provisioning the Service Ethernet Ports
The service Ethernet ports, ETH1 and ETH2 can only be configured with static IP
addresses. The IP addresses for the MGMT, ETH1 and ETH2 ports must be on
different networks/subnets.
Ethernet Active Connector
The Ethernet ports on the TP 2300/2700 can be mapped for use with either the
RJ45 connectors, R1 and R2, or the SFP connectors, S1 and S2. The SFP
connectors require 1000M optical transceivers.
1. Login at the admin or Config-user level.
2. Type
set ethernet active-connector eth1 s1-sfp and press Enter.