240 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 4 Provisioning
Testing TP 2300/2700 Provisioning
--------------------------------------------------
|Reference |Priority |config-PQL |use-config-pql |
|----------|---------|-----------|---------------|
|GNSS |1 |1 |enable |
|..........|.........|...........|...............|
|PTP |2 |3 |disable |
|..........|.........|...........|...............|
|SYNCE |4 |3 |enable |
|..........|.........|...........|...............|
|T1E1 |3 |3 |disable |
--------------------------------------------------
2. Type show ref status and press Enter.
– Verify that GNSS is qualified for Time Reference and Frequency
Reference. If GNSS is configured to be the main reference, verify that
GNSS is “selected”.
Time Reference Status
------------------------------------
|Reference |final-pql|status |
|----------|---------|-------------|
|GNSS |1 |selected |
|..........|.........|.............|
|PTP |16 |disqualified |
------------------------------------
Frequency Reference Status
------------------------------------
|Reference |final-pql|status |
|----------|---------|-------------|
|GNSS |1 |selected |
|..........|.........|.............|
|PTP |16 |disqualified |
|..........|.........|.............|
|SYNCE |3 |disqualified |
|..........|.........|.............|
|T1E1 |16 |disable |
------------------------------------
Verifying GNSS (TP 2700 only)
1. Type show gnss config and press Enter.
– Verify that the State is “enable”.
– Verify that the settings for PosMode, Track-mode, Mask, and Antenna
Delay match the desired values.