EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #118 background imageLoading...
Page #118 background image
118 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
show port-control
This command provisions the sync service port, legacy port, or packet time service
ports configurations.
Command Syntax:
show port-control
Example 1:
TP2700>show port-control
Response 1:
--------------------------------------------
|# |Port |State |IO dir |Signal/Format|
|---|-------|--------|-------|-------------|
|1 |t1e1 |enable |input |t1 |
|...|.......|........|.......|.............|
|2 |pps10m |enable |output |10MHz |
|...|.......|........|.......|.............|
|3 |tod |enable |output |cisco |
--------------------------------------------
Level : User, Config, and Admin
set port-control
Use this command to provision the sync service port, legacy port, or packet time
service port. This includes configuration of port states, port directions, port
connector types, and/or service types.
Command Syntax:
To provision the state for the T1/E1 port:
set port-control t1e1 state {enable | disable}
To provision the IO direction of the T1/E1 port:
set port-control t1e1 io {input | output}
Note: The IO direction for the TOD and PPS10M ports are not
configurable - they are both hardcoded as “output”.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish