098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 97
Chapter 3
TimeProvider 2300/2700 CLI Command Set
Static mode Parameters
IP address : 192.168.9.44
IP mask : 255.255.255.0
IP gateway : 0.0.0.0
Example 3:
To display the status of the Ethernet interfaces for the Ethernet management port:
tp2700> show ip status mgmt
Response 3:
mgmt0 Link encap:Ethernet HWaddr 00:B0:AE:00:00:05
inet addr:192.168.5.14 Bcast:192.168.5.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:70867 errors:0 dropped:0 overruns:0 frame:0
TX packets:1986 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:4511319 (4.3 MiB) TX bytes:162895 (159.0 KiB)
Interrupt:21 Base address:0xe000
Example 4:
To display the status of the Ethernet interfaces for the ETH2 port
tp2700> show ip status eth2
Response 4:
eth2 Link encap:Ethernet HWaddr 00:B0:AE:01:32:4A
inet addr:192.168.2.11 Bcast:192.168.2.255
Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:6 errors:0 dropped:0 overruns:0 frame:0
TX packets:32 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:360 (360.0 B) TX bytes:1920 (1.8 KiB)
Interrupt:128
Level : User, Config, and Admin
set ip
Use this command to provision the Host, Mask, and Gateway IPv4 addresses for
the Ethernet management port and ETH1 and ETH2 ports. It also supports the DNS
client function by provisioning the DNS server,
To Next Page
Loading...
Need help?
General