98 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
The IP addresses for the MGMT, ETH1 and ETH2 ports must be on different
networks/subnets.
The special value of 0.0.0.0 should be used for the gateway value if a gateway
router is not required. Support for IPv6 addresses will be added in a future release.
Command Syntax:
To provision the state of the IPv4 Ethernet interfaces for the specified port:
set ip state {mgmt | eth1 | eth2} ipv4 [enable | disable |
restart]
To set the IPv4 address, mask and gateway of the Ethernet interfaces for the
specified port:
set ip ip-address {mgmt | eth1 | eth2} ipv4 address
<addrv4_value> netmask <maskv4_value> gateway
<gatewayv4_value>
To provision the IPv4 address mode on the Ethernet management port as DHCP
or STATIC:
set ip address-mode mgmt ipv4 {dhcp | static}
To provision the DNS servers and domain for support of the DNS client function
in Ethernet management port:
set ip mgmt dns nameserver1 { nameserver_ip_address }
nameserver2 {nameserver_ip_address } domain { domain_name }
Example 1:
To restart the Ethernet management interface:
tp2700> set ip state mgmt ipv4 restart
Example 2:
To enable the IP interface for packet service port ETH1:
tp2700> set ip state eth1 ipv4 enable
Example 3:
Note: To configure a VLAN, use the command set vlan to provision
the IP addresses.
Note: For the configuration change to take effect, the interface must
be restarted with the
set ip state {mgmt | eth2 | eth2} ipv4
restart
command.
To Next Page
Loading...
Need help?
General