Symmetricom TimeProvider 2700 User Manual

188 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 4 Provisioning
Managing the User Access List
Changing a User’s Access Level
To change a user’s access level you must delete and then re-create the user. This
also provides an opportunity to change the password, if desired. Use the following
procedure to change the access level to “admin” for user “tester123”:
1. Login at the Admin level (see Logging In, on page 185).
2. Type
show user and press Enter to view the current list of users.
3. Type
set user delete tester123 and press Enter.
4. Type
set user add name set user add name tester123 access-level
admin
and press Enter.
The system will respond with:
For user password, only chars {a-z, A-Z, 0-9, ! ( ) - _ . ? ~ *}
are accepted
Password:
5. Type a password and press Enter. The password you enter will be the log-in
password for the user. The system responds with:
Confirm Password:
6. Retype the password and press Enter. The system responds with:
CLI user has been added: tester123
7. Type show user and press Enter to verify that the account exists.
8. Repeat Steps 3 through 7 to modify other user access levels.
Note:
User passwords can consist of alphanumeric characters, “~”, “*”, “(“,
“)”, “!”, “?”, “-”, “_”, and “.” with a minimum of 8 characters and a
maximum of 32 characters.
Usernames can consist of numbers, upper and lower case letters,
dash "-", and underscore "_", with a maximum of 20 characters.
Usernames cannot use a leading dash “-” or underscore "_" as the
first character.
For a description of user access levels, see Managing the User
Access List, on page 184.

Symmetricom TimeProvider 2700 Specifications

General

Brand	Symmetricom
Model	TimeProvider 2700
Category	Network Hardware
Language	English