EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #117 background imageLoading...
Page #117 background image
098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 117
Chapter 3
TimeProvider 2300/2700 CLI Command Set
ping
Use this command to ping the host specified by the address (xxx.xxx.xxx.xxx) and
display ping statistics from Ethernet maintenance port or PTP service port.
Command Syntax:
ping mgmt <ip-address>
ping {eth1 | eth2} [<vlan-id>] <ip-address>
Example 1:
To ping IPv4 address 192.168.5.100 from Ethernet management port
TP2700> ping mgmt 192.168.5.100 <enter>
Response 1:
Ping mgmt success
Response 1a:
Error: action failed
Ping mgmt failed
Example 2:
To ping IPv4 address 192.168.5.110, from ETH2 port, which has VLAN ID of 23:
TP2700> ping eth2 23 192.168.5.110
Response 2:
Ping eth2 success
Level : User, Config, and Admin
Note: To minimize system resource usage and deter denial of
service attacks, the system is configured to allow a maximum
ICMP ping request rate of 1 per second.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish