098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 243
Chapter 4 Provisioning
Testing TP 2300/2700 Provisioning
PTP Sync Limit : -7
PTP Announce Limit : -4
PTP Delay Limit : -7
PTP Clock Id : 00:b0:ae:ff:fe:03:46:05
PTP Priority 1 : 128
PTP Priority 2 : 128
PTP Domain : 0
PTP Timescale : auto
4. Type show ptp master status eth2 and press Enter.
– Verify that the port is enabled.
– Verify that the profile matches the desired setting.
– If clients are configured to use this master, verify that number of attached
clients matches the number of clients configured.
ETH2 PTP MASTER STATUS :
Port enabled : yes
Clock Id : 00:b0:ae:ff:fe:03:46:05
Port Number : 2
Profile : telecom-2008
Port state : master
Clock class : 6
Clock accuracy : within 100 ns
Timescale : ptp
Maximum allowed clients : 64
Number of attached clients : 8
Client load : 12%
Verifying PTP Input Client Functionality
1. Type show ptp client config eth1 telecom-2008 and press Enter.
– Verify that the PTP State is “enable”.
– Verify that the PTP settings match the desired values.
– Verify that the IP address for the master is set to the correct value.
ETH1 PTP CLIENT CONFIGURATION WITH PROFILE TELECOM-2008:
PTP State : enable
PTP TTL : 64
PTP DSCP : 0
PTP Unicast Negotiation : enable
PTP Unicast Lease Duration : 300
PTP Sync Interval : -6
To Next Page
Loading...
Need help?
General