EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 77
Chapter 3
TimeProvider 2300/2700 CLI Command Set
show ethernet
The show ethernet command displays the packet service ports auto-negotiation
state and speed for all Ethernet service ports.
Command Syntax:
show ethernet { config | status }
Example 1:
TP2700> show ethernet config
Response 1a:
-----------------------------------------------------------
| Port | Auto-neg | Speed | Active-connector |
|--------|-------------|-----------|----------------------|
| eth1 | enable | all | r1- rj45 |
|........|.............|...........|......................|
| eth2 | disable | 1000 | s2- sfp |
|.........................................................
Response 1b:
----------------------------------------------
|Port| Auto-neg | Speed | Active-connector|
|----|------------|--------|-----------------|
|eth1| enable | all | r1-rj45 |
|----|------------|--------|-----------------|
|eth2| enable | all | r2-rj45 |
----------------------------------------------
Example 2:
TP2700> show ethernet status
Response 2a:
Eth1 current speed: all
Eth2 current speed: 100M
Response 2b:
Eth1 current speed: all
Eth2 current speed: non eth-link connected on this port

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish