316 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Appendix B Specifications and Factory Defaults
Factory Defaults
Table B-33. SyncE Input ETH1 Port IP Parameters
Description Default Value Value Range
State Enable Enable | Disable
QL-State Enable Enable | Disable
Table B-34. T1/E1 Input Port Parameters
Description Default Value Value Range
T1/E1 Input Port State Enable Enable | Disable
T1/E1 Input Port Priority 3 1 - 10
T1/E1 Input Port Configured
PQL
31 - 16
T1/E1 Input Port
User-Configured PQL State
Disable Enable | Disable
T1/E1 Input Port Signal Type T1 T1 | E1
E1 Input Port Frame Type CCS CCS | CAS | freq2048khz
E1 Input Port CRC Enable Enable | Disable
E1 Input Port 1 SSM Bit 8 4 | 5 | 6 | 7 | 8
T1 Input Port Frame Type ESF D4 | ESF | freq1544khz
Table B-35. PTP Grand Master ETH2 Port IP Parameters
Description Default Value Value Range
IP Address 192.168.2.12 Valid IPv4 Address
IP Mask 255.255.255.0 Valid IPv4 Mask
Gateway 0.0.0.0 Valid IPv4 Address, special
value of 0.0.0.0 is used for
no gateway
State Enable Enable | Disable