EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #174 background imageLoading...
Page #174 background image
174 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
show vlan
Use this command to display the VLAN mode and VLAN configuration for a
specified service port, including VLAN ID, Index value, priority, state, and Host,
Netmask, and Gateway IP address.
Command Syntax:
To display the VLAN mode for all packet service ports:
show vlan mode
To display the VLAN configuration for the specified port:
show vlan config {eth1 | eth2}
Example 1:
To display the VLAN mode for ETH1 and ETH2:
TP2700> show vlan mode
Results 1:
VLAN Mode Configuration:
eth1: enable
eth2: disable
Example 2:
To display the VLAN configuration info for PTP client port ETH1:
TP2700> show vlan config eth1
Results 2:
Vlan configuration for eth1 port:
Idx VID P STATE Address Netmask Gateway/NextHop Destnetwork
1 11 0 en 10.11.11.101 255.255.255.0 0.0.0.0 n/a
2 12 0 en 10.12.11.101 255.255.255.0 0.0.0.0 n/a
Example 3:
To display the VLAN configuration info for PTP server port ETH2:
TP2700> show vlan config eth2

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish