098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 239
Chapter 4 Provisioning
Testing TP 2300/2700 Provisioning
ETH2 PORT PARAMETERS
IP state : enable
Static mode Parameters
IP address : 192.168.2.12
IP mask : 255.255.255.0
IP gateway : 0.0.0.0
3. Type show ip status eth2 and press Enter.
a. Verify that the IP address and mask match the configured values.
b. Verify that the third line of the results shows that the link is “UP”.
eth2 Link encap:Ethernet HWaddr 00:B0:AE:03:46:06
inet addr:192.168.2.12 Bcast:192.168.2.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:261951 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:16764776 (15.9 MiB)
Interrupt:128
Verifying the Reference
1. Type show ref config and press Enter.
– Verify that Reference Critera and Switch Mode settings match desired
values.
– Verify that Priority and Config-PQL and Use-Config-PQL settings match
desired values for Time Reference and Frequency Reference.
Reference Criteria : priority
Reference Switch Mode : AutoReturn
Time Reference Config
--------------------------------------------------
|Reference |Priority |config-PQL |use-config-pql |
|----------|---------|-----------|---------------|
|GNSS |1 |1 |enable |
|..........|.........|...........|...............|
|PTP |2 |3 |disable |
--------------------------------------------------
Frequency Reference Config