238 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 4 Provisioning
Testing TP 2300/2700 Provisioning
ETH1 PORT PARAMETERS
IP state : enable
Static mode Parameters
IP address : 192.168.1.12
IP mask : 255.255.255.0
IP gateway : 0.0.0.0
3. Type show ip status eth1 and press Enter.
a. Verify that the IP address and mask match the configured values.
b. Verify that the third line of the results shows that the link is “UP”.
eth1 Link encap:Ethernet HWaddr 00:B0:AE:03:46:05
inet addr:192.168.9.44 Bcast:192.168.9.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:33895260 errors:0 dropped:0 overruns:0 frame:0
TX packets:17018547 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:3079100330 (2.8 GiB) TX bytes:1457475560 (1.3 GiB)
Interrupt:128
ETH2 Output Port
1. Type
show ethernet config and press Enter.
a. Verify that the auto-negotiation and speed settings match the desired values.
b. Verify that the active-connector setting matches the connector being used.
----------------------------------------------
|Port| Auto-neg | Speed | Active-connector|
|----|------------|--------|-----------------|
|eth1| enable | all | r1-rj45 |
|----|------------|--------|-----------------|
|eth2| enable | all | r2-rj45 |
----------------------------------------------
3. Type show ethernet status and press Enter.
a. Verify that the speed for the port matches the settings.
eth1 current speed: none
eth2 current speed: 100M
2. Type show ip config eth2 and press Enter.
a. Verify that the IP address and mask are the desired values.
b. Verify the State for the port is “enable”.
tp2700> show ip config eth2
To Next Page
Loading...
Need help?
General