EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #153 background imageLoading...
Page #153 background image
098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 153
Chapter 3
TimeProvider 2300/2700 CLI Command Set
TP2700> show ref status
Response 2:
Time Reference Status
------------------------------------
|Reference |final-pql|status |
|----------|---------|-------------|
|GNSS |1 |disqualified |
|..........|.........|.............|
|PTP |3 |selected |
------------------------------------
Frequency Reference Status
------------------------------------
|Reference |final-pql|status |
|----------|---------|-------------|
|GNSS |1 |disqualified |
|..........|.........|.............|
|PTP |3 |selected |
|..........|.........|.............|
|SYNCE |3 |qualified |
|..........|.........|.............|
|T1E1 |16 |disqualified |
------------------------------------
Level : User, Config, and Admin
set ref
Use this command to provision the system's reference port(s) priority, configured
quality Level (PQL), reference selection criteria, and reference switching mode.
The Timing References includes GNSS (GPS/GLONASS), and PTP (with PTP
timescale) inputs.
The frequency references includes GNSS, T1/E1, SyncE and PTP inputs.
Command Syntax:
To set the priority for a time reference input:
set ref time priority {gnss | ptp} {1 - 10}
To set the config-PQL value for a time reference input:
set ref time config-pql {gnss | ptp} {1 - 16}

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish