Symmetricom TimeProvider 2700 User Manual

226 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 4 Provisioning
Setting the System Date and Time
Figure 4-23. Output Generation Behavior Commands
Example:
To provision the port 1 output behavior as squelch for the warm-up state, squelch for
the free-run state, ON for the holdover state, and AIS for the fast-track state:
1. Login at the Admin or Config-user level.
2. Type
set output-gen warm-up t1e1 squelch and press Enter.
3. Type
set output-gen free-run t1e1 squelch and press Enter.
4. Type
set output-gen holdover t1e1 on and press Enter.
5. Type
set output-gen fast-track t1e1 ais and press Enter.
Setting the System Date and Time
The TimeProvider 2300/2700 Time of Day can be set either by an external source,
or manually with the “set clock” command. You can set the time and date only for
the frequency references.
Example
1. Login at the Admin or Config-user level (see Logging In, on page 185).
2. Type
show ref status and press Enter to check the reference mode.

Symmetricom TimeProvider 2700 Specifications

General

Brand	Symmetricom
Model	TimeProvider 2700
Category	Network Hardware
Language	English