EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #81 background imageLoading...
Page #81 background image
098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 81
Chapter 3
TimeProvider 2300/2700 CLI Command Set
show gnss
This command displays the GNSS port state, position (latitude, longitude, height),
elevation mask value (positioning filter), mode of operation (manual or automatic),
and track-mode selection, GPS or GLONASS, or GPS+GLONASS. It also displays
information for all satellite vehicles being tracked: vehicle number, health, noise
ratio, satellite elevation, satellite azimuth.
Command Syntax:
To show the GNSS configuration:
show gnss config
To show the GNSS status:
show gnss status
Example 1:
TP2700>show gnss config
Response 1 :
GNSS Configuration
State : enable
PosMode : auto
Track-Mode : gps
Mask : 10
Antenna Delay : 0
GNSS manual position
Latitude : N37:22:43.425
Longitude : W121:55:34.815
Height : 13.7
Example 2:
TP2700>show gnss status
Response 2 :
GNSS Status:

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish