EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #218 background imageLoading...
Page #218 background image
218 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 4 Provisioning
Provisioning the PTP Output
Figure 4-20. One-Step Clock
Example 1 - Telecom-2008 Profile
Use the following procedure to configure the ETH2 port as a PTP master with the
Telecom-2008 profile:
1. Type
set ptp master active-profile eth2 telecom-2008 and press
Enter.
2. Type
set ptp master config eth2 telecom-2008 ptp-state enable and
press Enter.
3. Type
set ptp master config eth2 telecom-2008 ttl 100 and press Enter.
4. Type
set ptp master config eth2 telecom-2008 dscp 5 and press Enter.
5. Type
set ptp master config eth2 telecom-2008 two-step disable and
press Enter.
6. Type
set ptp master config eth2 telecom-2008 timescale auto and
press Enter.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish