Symmetricom TimeProvider 2700 User Manual

098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 219
Chapter 4 Provisioning
Provisioning the PTP Output
7. Type set ptp master config eth2 telecom-2008 priority-1 128 and
press Enter.
8. Type
set ptp master config eth2 telecom-2008 priority-2 128 and
press Enter.
9. Type
set ptp master config eth2 telecom-2008 domain 8 and press
Enter.
10.Type
set ptp master config eth2 telecom-2008 unicast-negotiation
Enable
and press Enter.
11.Type
set ptp master config eth2 telecom-2008 lease-limit 300 and
press Enter.
12.Type
set ptp master config eth2 telecom-2008 announce-limit -4 and
press Enter.
13.Type
set ptp master config eth2 telecom-2008 sync-limit -7 and
press Enter.
14.Type
set ptp master config eth2 telecom-2008 delay-limit -7 and
press Enter.
Example 2 - Default (Multicast) Profile
Use the following procedure to configure the ETH2 port as a PTP master with the
Default (multicast) profile:
1. Type
set ptp master active-profile eth2 default and press Enter.
2. Type
set ptp master config eth2 default ptp-state enable and press
Enter.
3. Type
set ptp master config eth2 default ttl 20 and press Enter.
4. Type
set ptp master config eth2 default dscp 25 and press Enter.
5. Type
set ptp master config eth2 default dither enable and press
Enter.
6. Type
set ptp master config eth2 default two-step enable and press
Enter.
7. Type
set ptp master config eth2 default priority-1 200 and press
Enter.
8. Type
set ptp master config eth2 default priority-2 200 and press
Enter.

Symmetricom TimeProvider 2700 Specifications

General

Brand	Symmetricom
Model	TimeProvider 2700
Category	Network Hardware
Language	English