Symmetricom TimeProvider 2700 User Manual

098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 275
Appendix A System Messages
System Notification Messages
Syslog messages are stored according to facility code and/or severity:
 Syslog messages with facility code 4 are stored in the Security Log.
 Syslog messages with facility code 20 and a severity of 2 | 3 | 4 are stored in the
Alarm Log.
 Syslog messages with facility code 20 and a severity of 5 are stored in the Event
Log.
 Syslog messages with facility code 21 are stored in the Command Log.
 Syslog messages with facility code 22 are not stored in the TP 2300/2700. They
can be forwarded to the remote syslog server.
System Notification Messages
Table A-1 provides a list of system notification messages. These messages are
logged and sent to a remote syslog server if configured. Alarms will also generate
an SNMP trap. See Tabl e A -2 for secondary index values, where applicable.
Notes: Transitory Events represent transitions that are short-lived,
such as when GNSS is selected as the Time reference (ID 024) or
when the SSM for the SYNCE/T1E1 input changes (ID 032).
Table A-1. System Notification Messages
Description
Event
ID
Msg
Level
Trans-
itory
MsgText Corrective Action
Entered
time/frequency
warm-up state
001 Minor No
Entered time/frequency
warm-up state
Transitioned out of
warm-up state
No action required
No action required
Entered
time/frequency
free-run state
002 Minor No Entered time/frequency
free-run state
Transitioned out of
free-run state
No action required
No action required

Symmetricom TimeProvider 2700 Specifications

General

Brand	Symmetricom
Model	TimeProvider 2700
Category	Network Hardware
Language	English